On Tue, 12 May 1998, Dee Jackson wrote:
> I just received a brake master cylinder rebuild kit that was made by PBR
> Automotive in Australia. ISTR the prevailing wisdom some time back was
> that the rubber bits from Down Under were less than what one would
> expect. Has anyone had any experience with this company, or should I
> send the kit back as a matter of course?
Almost all my rebuild kits were by PBR or another Aussie maker, MoProd.
No problems so far but I have not had much road use. It's surprising how
little the brakes get used when the car is up on blocks! :-(
-Malcolm
(learning to weld-- and getting better!)
|