>
>1. Clutch Release Bearing (or Throwout Bearing): The bearing to use is the
>throwout bearing for a 1975-1986 Toyota Landcruiser. This bearing has a
>Beck-Arnley/Worldparts part number of 062-0898. Other part numbers it is
>listed under are "RCT52S", "RB-0203", and "046", but you can just ask for a
>1975-86 Landcruiser Throwout bearing and you will get the right part. It
>is a larger OD than the stock TR-6 T/O bearing, but the ID is the same, so
>it presses onto the stock TR-6 carrier/sleeve. Shop around for the best
>price - I was quoted from a low of $40 to a high of $80 for the exact same
>bearing.
>
>Hugh Barber
>'73 TR-6
>San Jose, CA
>
Hi! Here in NZ the bearing is listed " RB126" & costs about US Dollar
$22.00 about half the cost in the USA.Still havnt found the right clutch
cover from a Saab 900, the parts book show lots of different types,can
anyone give year,motor type & any parts numbers. Cheers Ashley.
>
>At 07:26 PM 3/21/98 -0500, sukey wrote:
>>
>>I am switching over to the new and improved set-up for my 72 TR-6, aka
>>saab 900 pressure plate and Land cruiser throw out bearing. Problem is
>>that the bearing appears wrong. The auto parts store supplied me with a
>>"Federated Auto Parts" bearing, P/N 613010. This was supposed to be a
>>Land cruiser bearing. The I.D. of this bearing is only 1.575" compared
>>to a I.D. of 2.062 for the bearing I removed from the car. Did the
>>store just screw up or are there different size bearings for the Land
>>cruiser? Any help tracking this down would greatly be appreciated.
>>
>>Marty .
>>
>>
>>
>
>
|