I just used this stuff on the bottom of my seat sliding rails. You
sand or wire brush, then apply 2-3 coats within 2 minutes of each
other. The can says it dries black.
Well, it went on wet and clear and I was worried I bought junk.
Overnight, just as they said, it turned black everywhere there was
rust. On the parts of the rails that were silver and not rusted, I
don't see anything. The stuff is apparently still clear.
I intend on priming over it (even though the manufacturer says I can
paint directly on it), then using a rust inhibiting paint. I'll report
the results in 5 years.
Anyone have any experience with Exxtender by Permatex?
|