Hello all,
I am having a bit of a problem installing a new set of pads on the 6. I
got the rotors turned and attempted to install the new pads, no go, won't
fit. Put the old ones back on and they just barely slide onto the disk.
I tried the manual trick of opening the bleed valve whilst pressing in
the cylinders. They moved a little but not nearly enough. Is there
something I am missing here? How far should the cynlinders push back
into the calipers? Any tricks here. It sure wasn't this tough when I
did the Mustangs brakes!
Joe Burlein
72 TR-6
Melbourne, FL
|