Scott,
If I correctly understand which snaps you are referring to, they (the
snaps) attach in the following places:
1. Two attach to the male snaps which are _supposed_ to be on the rear
bulkhead panel (the panle which conceals the fuel tank). If you look in
the TRF catalog at this panel (can't remember the page # and don't have
said book at work), you will see that the panel actaully takes six male
snap studs. Perhaps these are missing on your car?
2. The two out ward ones attach to two male studs on the side panels
just under the top frame (once it's folded). Again consul the TRF
catalog as it's the only one of the big 3 which illustrates this level
of detail.
The straps keep the cover from flailing around when driving with the
roof down at "speed".
Good luck.
Peter Zaborski
76 TR6 (CF58310 UO)
Calgary AB Canada
> -----Original Message-----
> From: scott suhring [SMTP:suhring@lancnews.infi.net]
> Sent: Sunday, August 10, 1997 5:09 PM
> To: triumphs@autox.team.net
> Subject: Hood cover Installation
>
> I put on a Robins Hood Stowage Cover today for my '70 TR6.
> The outer snaps went on fine with no dificulty. My question
> is where are the four vinyl strips which hang down from the
> cover section above the rear axel box supposed to attach?
>
> There are no male snap ends except for those which are on the
> support cross bar of the hood frame, but the straps don't seem
> to be in line with these. The two strips on the center piece of
> vinyl already have holes punced in them while the outer strips
> which are by the b-post do not.
>
> Any help would be much appreciated.
>
> Scott Suhring
> Elizabethtwon, PA
> '70 TR6
|