Scott,
Take a look at page 418 in TRF spare parts catalog and you will see that
2 male snaps are located on either side of the rear bulkhead trim panel
at the first seam from the top(assuming you have the correct trim panel
for '70) Two more snaps are located on the rear quarter panels(doglegs)
also at the first seam from the top. The little washers are important
here so that the snaps stand proud of the panels to allow the female snap
to properly fit in place. TRF almost always has these items in stock.
Hope this helps,
Jim Davis
Fortson, GA
'75 TR6 CF38690UO
'75 TR6 CF37325U
On Sun, 10 Aug 1997 16:08:36 -0700 scott suhring
<suhring@lancnews.infi.net> writes:
>I put on a Robins Hood Stowage Cover today for my '70 TR6.
>The outer snaps went on fine with no dificulty. My question
>is where are the four vinyl strips which hang down from the
>cover section above the rear axel box supposed to attach?
>
>There are no male snap ends except for those which are on the
>support cross bar of the hood frame, but the straps don't seem
>to be in line with these. The two strips on the center piece of
>vinyl already have holes punced in them while the outer strips
>which are by the b-post do not.
>
>Any help would be much appreciated.
>
>Scott Suhring
>Elizabethtwon, PA
>'70 TR6
>
|