triumphs
[Top] [All Lists]

Re: Ignition Wiring

To: triumphs@Autox.Team.Net
Subject: Re: Ignition Wiring
From: Spitfire15@prodigy.com ( CHRISTOPHER J REILLY)
Date: Tue, 17 Jun 1997 14:22:34, -0500
-- [ From: Chris Reilly * EMC.Ver #2.5.3 ] --

Michael;

I am just finishing up this particular project, although I opted for
fully replacing
the switch with a race type setup mounted in the radio bracket on my
spitfire.
Don't have the diagram handy, but I can send you the wires needed for
just the 
starter circuit... oh... do you have a triumph spitfire ?  Hope to have
pictures of 
the finished work on a site someday... 



Chris 
It's official if I EVER sell this car I WILL be a DPO... 
'78 Spitfire ( electrical project almost completed ) 

-------- REPLY, Original message follows --------

> Date: Monday, 16-Jun-97 04:39 PM
> 
> From: Michael D Fatsi          \ PRODIGY:     (WEZA65A)
> To:   Triumph List             \ Internet:    (triumphs@autox.team.net
)
> 
> Subject: Ignition Wiring
> 
> I have had some trouble with my starter switch. I have had bad luck 
as this
> will be the third ignition switch that I have gone through in  seven 
years. I
> have decided to take an alternate path to fixing this  problem. The
solution I
> want to go with is a push button switch. I  have looked at the wiring
diagram
> and it is not immediately obvious  how this should be wired up. I plan
to leave
> the current keyed  ignition switch in place and use it merely as a on
/off -
> column lock.
>   Any suggestions on how I should proceed.
> -MF
> 

-------- REPLY, End of original message --------



<Prev in Thread] Current Thread [Next in Thread>