Paul Vandal<PVANDAL@aol.com> Wrote:
> In the process of dismantally my 250 I realized the RH door was replaced
> during its life time and the controls, though worked, were jury rigged since
> the attachment points for the regulator and striker had been attached with
> newly drilled holes out side the designated areas, hence, I need a RH door.
> Does anyone know the compatability of doors of the related TR models?
>
Paul,
I beleive the only differences were 1) the interior trim. i.e. panel
& piece above the panel, near the glass 2)the holes for the pop rivits
that hold on the trim strip. The TR4 &TR6 have no holes, the TR 4a holes
are lower, because the center of its skinnier strip sits nearer to the
body line, and a TR 250 door, which "fits juuust right".
If I were you, I'd search for a TR 6 door, they are the most numerous,
the most recently manufactured, and are not wrongly drilled.
Good Luck,
JOE IV
TR 250
WALLINGFORD, CT. USA
|