Dave F. writes:
> When I replace the bearing, can I
>simply reinstall the same shim on the pinion shaft or will
>I have to set up the clearances all over again?
****************************************
Sorry, but you will really have to set up the clearances again - but diff
bearings don't _normally_ cause vibration, noise yes but not vibration
(unless really severe and would be noisy as hell). I would check every
thing else out first before attacking the rear end. What a nasty job!
Barry Schwartz
Bschwartz@encad.com (San Diego)
72-V6 Spitfire (daily driver)
70 GT6+ (when I don't drive the Spit)
70 Spitfire (project on hold for now)
|