GT6 engine->TR6 tranny

[mah16@cornell.edu (Marie A Harkins)]

It appears as though I could take the transmission (w/OD), clutch,
flywheel, and rear engine plate from a 72 TR6 and install them on a GT6
engine. Questions:

1. Has this been discussed before?

2. What problems have I overlooked?

3. Because the TR6 flywheel is heavier than the GT6's should it be
lightened/balanced?

4. Will I be less than pleased with the resulting ratios?

5. Why would I do this??

Thanks for any advice or comments in advance.

Bill King
mah16@cornell.edu