Dave -
You might check some of the Jaguar places but not sure if they have
the Flange style, also some older 4x4's might have the flange for the Dana
44's. I will have one when I go the other way around by removing the 2.88's,
but not for a bit.
This one from Speedway might work, but not sure about
driveshaft length since not a flange style.
http://www.speedwaymotors.com/Jaguar-Yoke,3780.html
I am not sure about
'chevy' u joints but I would guess that is a 1310 as well.
Sandy
-----
Original Message ----
From: Dave Munroe <dave@munroe.ca>
To:
tigers@autox.team.net
Sent: Thursday, April 9, 2009 8:55:26 AM
Subject: Re:
[Tigers] Differential drive shaft flange
Hi Guys;
I am in the middle of a
posi installation and a gear swap from 3.07 to original 2.88's in my Tiger's
rear end.
We discovered on dismantling that the P.O. had installed an
American ring and gear set with the fine (26 tooth) pinion shaft and matching
flange.
My 2.88's have the original Tiger 10 tooth pinion shaft. Sooooo...
Anyone have a matching, original Tiger, 10 tooth flange they want to sell, or
know where I might get one?
Many thanks in advance for any help finding one...
Cheers,
Dave
B382000450 _______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|