George Re wrote:
> Hello I have a question got my block back (260) from the machine shop
> and was putting
> in the first piston my question is the rod bearing I took out had a
> oil hole in the upper bearing
> but the bearing that I am installing DO NOT have a oil hole in the
> upper bearing? are these
> the correct bearing? the parts store say they are correct
>
> Thanks
> George
>
>------------------------------------------------------------------------
>
>_______________________________________________
>Support Team.Net http://www.team.net/donate.html
>
>Tigers@autox.team.net
>http://autox.team.net/mailman/listinfo/tigers
>
>http://www.team.net/archive
>
Rod bearings are made such that either half of the pair can go on the
rod cap or the rod side.
mayf
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|