Tim -
Have you scavanged through the McMaster Carr catalog on line they have that
type of stuff.
Search - sleeve bearings
and you can select inner and outer diameter and length. They will have it in 10
different materials and styles. I just looked and they have them in bronze.
Sandy
----- Original Message ----
From: "Ronak, TP (Timothy)" <Timothy.Ronak@crna.akzonobel.com>
To: Tigers <tigers@autox.team.net>
Sent: Thursday, March 20, 2008 9:17:52 PM
Subject: [Tigers] Bushing for the pulley and fan for the Edelbrock conversion
Pulley and Fan - the stock pump fan/pulley flange is 1" in diameter and
the Edelbrock pump is only .745" in diameter (3/4") this poses a problem
as the shaft will now not center the pulley and the fan. I need to find
a bushing with a .745" inside opening with a 1" outside diameter. ANY
SUGGESTIONS before I go spend to make one???? I would like to source
this tomorrow if I can as I need to get this figured out before I do the
second car.
So if anyone has a cost effective suggestion on the 3/4" to 1" bushing
... I suspect I need it 1/8 - 3/16" thick but will know more tomorrow
after I get the pumps pressed and see how far the 3/4" shaft extends
beyond the flange. (I am doing this to two cars as I am helping another
tiger owner as well)
If you have the 3/4" to 1" bushing and would be willing to sell me 2 or
3 that would be great as well.
Best Regards,
Tim Ronak
Services Consultant
Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691
Bus: 949-305-5393
Fax: 425-955-6268
Cell: 949-289-3357
email: timothy.ronak@crna.akzonobel.com
Personal email: timronak@cox.net
You are subscribed as sganz@pacbell.net
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Tigers@autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
|