Tim
The backing plate is a large metal piece that goes between the
flywheel and the block. It looks like a gasket for the bell housing with
the same outline and holes for the bolts and pins plus a big hole for the
crankshaft and starter motor.
My parts list this as C20Z-7007-A; as long as the part is for a 5 bolt block
your OK.
If you needed to you could make one by tracing the bell housing and marking
all the holes on .080" sheet steel. It would take a bit of work but could
be done.
Ron Fraser
-----Original Message-----
From: owner-tigers@autox.team.net [mailto:owner-tigers@autox.team.net] On
Behalf Of Tim Webster
Sent: Sunday, October 29, 2006 1:00 PM
To: tigers@autox.team.net
Subject: Flywheel dust cover
Listers,
Now have the 260 all lined up with the Toploader. I am, however, stuck on
the flywheel backing plate. My parts list shows Part # C40Z-7007-A. It is
not depicted in the diagrams so I am not entirely sure what it is supposed
to look like.
Is this a readily obtainable piece? Any clues appreciated.
Regards,
Tim
B9470694
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.408 / Virus Database: 268.13.17/505 - Release Date: 10/27/2006
|