To: | tigers@autox.team.net |
---|---|
Subject: | RE: Center roll-over not correct |
From: | itswonderful@attbi.com |
Date: | Fri, 07 Feb 2003 22:35:48 +0000 |
This part bothers me. Wouldn't the movement be highest and equal at lowest lifts and again at highest lifts? Your working on equal parts of the arc on both sides of 90 degrees in this method. Frank > Ideal geometry will have a strike area of approximately .060" [1.5mm] wide, > central on the valve and have the major amount of roller movement at low lift > where the spring pressure is least. |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Center roll-over not correct, itswonderful |
---|---|
Next by Date: | Re: Center roll-over not correct, Craig Wright |
Previous by Thread: | Re: Center roll-over not correct, itswonderful |
Next by Thread: | Re: Center roll-over not correct, Craig Wright |
Indexes: | [Date] [Thread] [Top] [All Lists] |