To: | tigers@autox.team.net |
---|---|
Subject: | Re: Center roll-over not correct |
From: | itswonderful@attbi.com |
Date: | Fri, 07 Feb 2003 22:30:05 +0000 |
I should clarify that I think it is possible to get the contact patch symmetrical with this approach but half lift will not occur when the tip is at the centerline of the stem but rather somewhere past centerline. Frank > Also if you take a look at the geometry involved you will see that > it is technically impossible to achieve total symmetry about the valve stem > centerline using my original method, at least with typical roller valve gear. > |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | RE: Center roll-over not correct, Palmer, Robert L. |
---|---|
Next by Date: | RE: Center roll-over not correct, itswonderful |
Previous by Thread: | RE: Center roll-over not correct, Palmer, Robert L. |
Next by Thread: | RE: Center roll-over not correct, itswonderful |
Indexes: | [Date] [Thread] [Top] [All Lists] |