"Rose, Mark G" wrote:
>
> Steve-
>
> I was reading your email to Chris a few weeks ago and you mentioned "the
> original thick washer spacers between the motor mount and the block"
>
> What do the washers look like. I'm rebuilding my father-in-laws car and they
> might be in a box somewhere. If I can't find them, what thickness were they?
>
> I appreciate your help.
> Mark
> B382000974
Mark,
Since I put them back on, I will have to get under the car to measure,
but my "Quesstimate" would be about as thick as a quarter.
I do have the original mounts, and an impression of the washer is still
on the steel that faces the two block threaded holes.
My measurements of it's "shadow" are 7/8 in. OD, with a center hole to
fit the bolt. The hole in the mount is 9/16 ths.
This cleared my trimmed fan, before they were left out.
Steve
--
Steve Laifman < Find out what is most >
B9472289 < important in your life >
< and don't let it get away!>
<SLaifman@SoCal.RR.com>
<http://www.TigersUnited.com/gallery/SteveLaifman.asp>
_/_/_/_/_/_/_/
_/ _/_/_/ _/_/_/ _/
_/ _/ _/ _/ _/ _/ _/_/_/_/
_/ _/ _/ _/ _/ _/ _/
_/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
_/
_/_/_/
|