tigers
[Top] [All Lists]

RE: FW: Floor removal

To: "'editor@tigersunited.com'" <editor@tigersunited.com>,
Subject: RE: FW: Floor removal
From: "Ronak, TP (Timothy)" <Timothy.P.Ronak@akzo-nobel.com>
Date: Thu, 2 Dec 1999 20:42:58 -0600
Steve,
                Steve wrote:
                (Providing, of course, that you can get the two ends of the
spot welder to press
                hard on both sides of the 'sandwich', which is held
together.  This is sometimes
                difficult if the car gets in the way of the spot welder head
clamp, or holding
                fixture clamps.)



You are right but my assumption is that the surfaces are clean and if you
are doing "post factory" then you would have a hole in one sheet and do a
button weld to the other creating the spot weld.
Regards,
Tim


<Prev in Thread] Current Thread [Next in Thread>