I would recommend the slave cylinder collar that goes inside the
bellhousing.
PAW has them for about $250.
Doug
-----Original Message-----
From: MWood24020 <MWood24020@aol.com>
To: KJENSSEN@aol.com <KJENSSEN@aol.com>; tigers@autox.team.net
<tigers@autox.team.net>
Date: Tuesday, April 28, 1998 11:22 PM
Subject: Re: bellhousing needed
>Kirt-
>There are a number of sources for an appropriate slave cylinder bracket,
>including Sunbeam Specialties. However, most are just an aluminum plate cut
in
>the correct pattern. If you have anything besides a very light pressure
plate,
>they will just flex and give terrible clutch feel. A solution is to weld
ribs
>onto the back surface or just fabricate your own out of heavier stock with
>reinforcement on the back surface.
>Was the dual pattern bellhousing aluminum or cast iron? I've never seen one
>that was aluminum, but I hear they exist.
>Mike Wood
>B382002273
>
|