This is what I figure is needed,
2ea 1 5/8" grip, 4 3/4" total length, 1/2"DIA X 20TPI
2ea 1 5/8" grip, 5 1/2" total length, 1/2"DIA X 20TPI
The grip is same as stock, the length is not. These specs should yield a
bolt that sticks a little more than 3/4" out of the top of the hole using
the stock thick flat washers plus a SAE type locking washer on the bottom
side. I tried to be pretty careful with my measurements but if anybody
knows that these are not the correct specs please let me know!
At 09:26 AM 2/12/98 EST, you wrote:
>Frank;
>If you would give me the dimensions of the bolts that should be used I could
>look around Detroit. I've almost always been able to find most of the unusual
>attaching hardware that I need. I won't find any Wentworth however, if that's
>what they are, so maybe that should be checked out.
>If it's a good idea, maybe others are interested.
> John Logan
>
>
Frank Marrone MK I Tiger B9471116
marrone@wco.com '97 Crown Vic LX
Yamaha Seca 900 (aka XJ900RK)
'79 Spitfire
'66 Ford LTD
'88 Nissan 4WD p'up
|