>The method is widely known in Europe. In hot engine water and steam cause
>heat shock, which "explodes" carbon deposits from combustion chamber,
>piston and valves.
>
>I think the risk is, that some of loosen deposits may stuck between valve
>and seat, and valve may thus burn.
>
>Run warm/hot engine faster than idle, about 2000 3000 rpm. Pour water
>slowly to carb / carbs, I quess half to one cup (coffee-) water in about 10
>seconds, maybe less is enough. If all goes well, pistons and head are as
>clean as they wore washed with hot steam. :-)
>
>I am sure someone has better and more detailed method than this, but she
>maybe don't tell us.
>
>Larry, Finland
Larry,
Your description of the process is quite accurate. When the engine starts
to die down you slow up on the water. Back in the 60's doing a "water
tuneup" on older cars was quite common in the U.S.. My 53 Ford and my 54
Chevy all recieved the treatment. I learned the technique from my father.
He worked on Model T and A Fords growing up, then progressed to an engine
rebuilding business with his brothers and then worked as a Ford dealer
mechanic until 1953. He related tearing down an engine that had a water
injection setup that operated from the engine vacuum. The combustion area
was very clean. J.C. Whitney has sold water injection systems from time to
time. Some pulling tractors use water injection to get more power with out
melting the turbocharger.
Tom Calvert
|