Hi Gang:
I'll bet that I am not the only person with a Tiger that has a loose (falling
out) turn signal activator arm. The torque that using the thing puts on
those splines on the arm really takes a toll (mine is nice and smooth).
My solution was to go to Home Depot, where I found 5/64-inch tension pins (in
the fasteners section). Holding the signal arm and the switch together in
the correct position I drilled a 5/64 hole thru both and squeezed one of the
pins into it. Perfect fit. Just the right length.
My appologies if this is old news to the group, but I was so impressed with
the fact that the pin was a perfect fit that I had to tell sombody.
Thanks for the bandwidth.
Rick Hoefle (1964 Tiger B9470508)
|