spridgets
[Top] [All Lists]

Re: [Spridgets] Roller Throw out bearing

To: "'Tim Collins'" <thcollin@mtu.edu>, <spridgets@autox.team.net>
Subject: Re: [Spridgets] Roller Throw out bearing
From: "Dean Hedin" <dlh2001@comcast.net>
Date: Tue, 29 Nov 2011 14:54:22 -0500
That's the kind of solution I was thinking about.

I wonder if the Honda bearing would fit in the Spridget throwout.

I think if I were to do something like that I would turn it in the lathe
(make a sleeve if needed) and then use Locktite retaining compound to 
hold it together.  

Thanks for posting.

-----Original Message-----
From: spridgets-bounces@autox.team.net
[mailto:spridgets-bounces@autox.team.net] On Behalf Of Tim Collins
Sent: Tuesday, November 29, 2011 2:32 PM
To: spridgets@autox.team.net
Subject: [Spridgets] Roller Throw out bearing

Check out the D.I.Y. roller throw out bearing over at the MG Experience.
<http://www.mgexperience.net/article/diy-roller-throwout-bearing.html>http:/
/www.mgexperience.net/article/diy-roller-throwout-bearing.html 
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums

<Prev in Thread] Current Thread [Next in Thread>