To: | spridgets@autox.team.net |
---|---|
Subject: | [Spridgets] Roller Throw out bearing |
From: | Tim Collins <thcollin@mtu.edu> |
Date: | Tue, 29 Nov 2011 14:32:24 -0500 |
Check out the D.I.Y. roller throw out bearing over at the MG Experience. <http://www.mgexperience.net/article/diy-roller-throwout-bearing.html>http://www.mgexperience.net/article/diy-roller-throwout-bearing.html Tim Collins http://www.flickr.com/photos/12702006@N07/sets/ _______________________________________________ Donate: http://www.team.net/donate.html Suggested annual donation $12.75 Archive: http://www.team.net/archive Forums: http://www.team.net/forums |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | [Spridgets] Ron Soave, Matt P |
---|---|
Next by Date: | [Spridgets] Roller Throw out bearing, Tim Collins |
Previous by Thread: | [Spridgets] Trying to figure out where to get a plug, Kim Tonry |
Next by Thread: | [Spridgets] Roller Throw out bearing, Tim Collins |
Indexes: | [Date] [Thread] [Top] [All Lists] |