John, Larry,
I stand corrected (and slightly embarrassed). I was just SURE that.
Getting old really sucks, sometimes :-)
Bud Osbourne
-----Original Message-----
From: John D. Caffrey [mailto:jdc6@Lehigh.EDU]
Sent: Thursday, August 21, 2008 8:43 PM
To: Bud Osbourne
Cc: 'Deikis,John G'; 'Spridget List'; 'Hal Faulkner'; 'Larry Daniels'
Subject: Re: [Spridgets] Air pump ports
The idea of 7/16-20 came from measuring the mating air manifold. It is a
7/16-20 UNFstraight thread, it is not a tapered pipe thread. 1/8 pipe is
a bit smaller and the pitch is close so a 1/8-27 pipe plug screws in,
that doesn't make it the thread size.
John, Fogelsville PA
Bud Osbourne wrote:
Nope. The B series head uses the same size as the A series. > Dunno
where the idea of 7/16 x 20 came from.
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|