Switch plugs 1 and 4, 2 and 3 to tell quickly.
--- On Sun, 8/10/08, Lester <oldsaabguy@comcast.net> wrote:
> From: Lester <oldsaabguy@comcast.net>
> Subject: Re: [Spridgets] Can't get new engine to fire cont.
> To: kidjoevid@yahoo.com, "Spridgets List" <spridgets@autox.team.net>
> Date: Sunday, August 10, 2008, 12:23 PM
> Remember first reply.. dizzy is 180 degrees out... guess
> what, dizzy
> is 180 degrees out..
>
> Lester
>
>
> On Aug 10, 2008, at 9:31 AM, Joe Lansing wrote:
>
> > OK - I tried using a plug wire straight to #1 from
> coil. It did not
> > fire. I pulled the plug and turned it over, and there
> was spark at
> > the gap. I'll try a new coil. But one question -
> could my engine
> > builder have re-assembled with the cam so far out of
> time with
> > everything that it won't run? I'm pretty sure
> it isn't, as when #1
> > is TDC, both valves for #1 are open, distributor drive
> shaft slot is
> > at 2:00.
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as soavero@yahoo.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|