On Jul 19, 2008, at 9:34 PM, Dean Hedin wrote:
> I am in the proccess of making copies of all my original interior
> vinyl & hardura bits.
> The originals are in very poor condition.
>
snip
>
>
> I am missing the mat directly behind the seats, but I have good
> photos to make a duplicate.
> That mat has two cut outs for the top bows to slip into when they
> are in the stored position.
> At this location in the cockpit sheet metal there are two screw
> holes located at a diagonal to each other.
> Was there a piece of hardware that was mounted at these holes, under
> the mat, that supported the bows?
> If so, what did this part look like?
Imagine a box with a hole in the top. That's it. now imagine it with
some wings to screw it into those holes. Above those holes should be
another single hole that had a rubber bumper in it so that the bow
went into the hole and the bumper gave it something to rest against
when it was leaned back to be tied.
>
Lester
>
snip
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|