Okay ... I peeked. It's easier to access on-line than it is to wade through
the pile of book in which the Datusn manual resides.
Standard baulk-ring-to-cone clearance: 0.0433 - 0.0551 (1.10 - 1.40 mm)
Thanks for the link ... I did not know it existed.
Pete
----- Original Message -----
From: "David Lieb" <dbl@chicagolandmgclub.com>
To: "Spridgets" <spridgets@autox.team.net>
Sent: Monday, May 19, 2008 5:46 PM
Subject: Re: [Spridgets] Datsun Rebuild
>> As a side note, I'm thinking that the minimum tolerance for a baulk ring,
>> once it is pushed down against the gear, is something like 0.40 or 0.41.
>> Don't quote me on that ... it's just that I am too lazy to go look it up
>> right now.
>
> BTW, Rivergate has a decent-quality scan of the manual at
> http://www.rivergate5speed.com/transmission_book_300dpi.pdf
> http://tinyurl.com/5ub2ny
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as pdx.pete@verizon.net
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|