isn't it easier to put the fuel line in with the engine / gear box out?
????
brake and clutch run up over the battery area they are easy to fabricate
and put in with exception of the brake pipe thar runs from the union on the
right inner fender to the left front wheel under the engine. that one you
might want to make up and clip in place ahead of time....?
chuck.
> [Original Message]
> From: Frank Clarici <spritenut@exit109.com>
> To: Dan Gillitzer <dang@ticon.net>
> Cc: <spridgets@autox.team.net>
> Date: 03/04/2005 6:59:42 PM
> Subject: Re: Reassembling/reinstalling engine: preferred order
>
> Dan Gillitzer wrote:
> > Hi folks, 62 Mk2 Sprite, body is bare,
>
> Put the slave cyl on BEFORE the engine/trans slide all the way in.
> Starter too. Everything else can go on after it's in place.
> As for the motor mount...... Bolt the mount to the body on the steering
> column side, what ever hand drive you have. Remove the mount and
> bracket from the other side and slip it in before the engine is
> completely lowered in place.
|