spridgets
[Top] [All Lists]

Re: Spridget Frame Dimensions

To: "Tom Speed" <tspeed@carolina.rr.com>
Subject: Re: Spridget Frame Dimensions
Date: Mon, 2 Aug 2004 14:20:23 -0700
Cc: spridgets <spridgets@autox.team.net>
References: <002a01c478c6$9e311110$6500a8c0@tomsr>
Hello Tom,

       the BENTLEY manual gives the following :

       Width between centres of the suspension inner pivot bolt
       (front) 18 3/8"  [point A-A']

       Width between centres of the suspension inner pivot bolt
       (rear) 18 3/8"  [point B-B']
       

       Width between inside frame side members 11"  [point C-C']

       Width between ouside of rear spring support members 37 1/2"
       [point D-D']

       from the pic it looks like after these are established to check
       the diagonal measurements, (not given) from each of these
       points to the opposite side to make sure that they match,
       i.e.  from point A to B', A to C', A to D', the same as from
       A' to B, A' to C, A' to D, respectively, .. from B' to C,
       B' to D, etc, etc, etc,..




-- 
Best regards,
 Bill                            mailto:pythias@pacifier.com
   "66 Sprite

Check out the new British Cars Forum:
http://www.team.net/the-local/tiki-view_forum.php?forumId=8





<Prev in Thread] Current Thread [Next in Thread>