Bill Mantz wrote:
> Does anyone know how far a pressure plate needs to be depressed before the
> clutch engages? (1275 1971 Midget) Everything points to the clutch fork
> being bent, but it doesn't look bent. Replaced it 2 years ago because a
> previous one bent (which was definately noticeable)Had the engine out twice
> now in the last 2 weeks trying to resolve this problem.
Clutch fork in backwards? BTDT but only once.
too short of a clutch slave pin? Should measure 2 11/16: fron center of
hole to end. Maybe try sticking a nut behind it and see if it works.
Extend-o-pin, but be carefull it doesn't extend too much or you will eat
the release bearing.
--
Frank Clarici
Toms River, NJ
2 Sprites, 2 Midgets
A car doesn't just take us places, it's a place all by itself.
http://www.exit109.com/~spritenut
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|