To: | thistle_3619@yahoo.com, spridgets@autox.team.net |
---|---|
Subject: | Re: Hydraulic Line for CLutch |
Date: | Tue, 23 Oct 2001 17:26:01 EDT |
In a message dated 10/23/2001 4:39:54 PM Eastern Daylight Time, thistle_3619@yahoo.com writes: > . Any ideas and help would be > appreciated. Also recommendations on running and > routing of the line would help. > > Jim: If you don't use a flexible section of line between the master and the slave, put a loop in the line. That way it will flex instead of bend when the engine torques. The bending will eventually break the line. --David C. |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Another nut(ty) question, Unknown |
---|---|
Next by Date: | Re: Cherry Red Paint Code, Unknown |
Previous by Thread: | Re: Hydraulic Line for CLutch, Unknown |
Next by Thread: | Re: Hydraulic Line for CLutch, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |