To: | spridgets@autox.team.net |
---|---|
Subject: | re: Advice on pulling motor |
Date: | Wed, 3 Oct 01 13:50:51 EDT |
per SD & Frank... >>> Anyone have any bad experiences using the valve cover bolts? >> >>I have crushed a few valve covers and bent a few V/C bolts. How 'bout a piece of heavy angle-iron long enough to bolt to both valve cover bolts, then a series of holes drilled long the vertical part to have a choice of balance points? This would make sure you got a straight pull on the v/c bolts so there's no bending force. Ed in NC Cat tails don't stretch, but their claws do. :-) |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | re: Wheel clunk - advice?, Unknown |
---|---|
Next by Date: | Another One FS on Ebay, Unknown |
Previous by Thread: | Re: Re: Advice on pulling motor, Unknown |
Next by Thread: | Re: Advice on pulling motor, Unknown |
Indexes: | [Date] [Thread] [Top] [All Lists] |