RIGHT ON!! My head gasket job turned into a full engine restoration and how
can one put a lovely clean engine back into a dirty engine bay? Still
working on the body... and then paint... and probably the interior after
that.
Toby
-----Original Message-----
From owner-spridgets at autox.team.net
[mailto:owner-spridgets@autox.team.net]On Behalf Of DLancer7676@cs.com
Sent: Tuesday, October 02, 2001 2:55 PM
To: SDOliner@aol.com; mgagne@unc.edu; spridgets@autox.team.net
Subject: Re: Advice on pulling motor
In a message dated 10/2/2001 2:31:47 PM Eastern Daylight Time,
SDOliner@aol.com writes:
> Going to pull the engine to clean the engine
> compartment. I bet you don't have dust balls under your bed either.
>
Hey David. Remember this is a Spridget. Just "Going to pull the engine to
clean the engine compartment" usually results in a complete engine rebuild.
Every job I have ever started on these cars began with the word "Just. . ."
and ended with "Damn. . ." <g>
--David C.
|