My distant recollection on the Bug rear trani mount is that there
are 3 separate rubber block mounts (2 side & 1 bottom center)
attached /encapsulated in a crossmember.
I doubt u can replace anything without unbolting the 2 bolts that
hold the crossmember to the body and the 4 bolts that attach to
the trani, and then drop the whole assy out.
Mike L.
60A,67E,59Bug
----- Original Message -----
From <DLancer7676 at cs.com>
To: <Rikrock@aol.com>; <spridgets@autox.team.net>
Sent: May 4, 2000 9:34 PM
Subject: Re: Bugeye rear tranny mount???
> In a message dated 5/4/2000 9:10:13 PM Eastern Daylight Time,
Rikrock@aol.com
> writes:
>
> << How the heck do you get what
> is left of the old one out, and the new one in? On my car, the
rubber is
> crimped. Do I just dig the old rubber out, bend the tabs back,
set the new
> one in place and hammer away to get the tabs to hold it?!?!
Some sort of
> trick? >>
>
> Good question, Rick!! I was wondering about that myself--I will
be anxious
> to see what the listers have to say.
>
> --David C.
>
|