I tried by having a machine shop do this by aligning in a jig and using 2
different reamers but they were off by just a couple thousandth's so I had
to purchase new bushings and sent to Merryman Modifications to have them use
the stepped reamer for the correct fit.
Just one persons experience....
Leo
-----Original Message-----
From: Gary Barker <gbarker@citynet.net>
To: spridgets@autox.team.net <spridgets@autox.team.net>
Date: Sunday, November 29, 1998 10:44 AM
Subject: Bushing
>I was going through the Moss Catalog and was ordeing 4 trunnion bushings.
>At the bottom of the page, there was a note that you needed a reamer tool
in
>order to install thies bushes. The cheapest I've found this tool in for
>$199.00. I don't want to pay this amount for a tool I'll probably just use
>for this one time instilation. My questionis: Is there a way to fit
these
>bushings without this tool? And if so, how do you do it? I appreciate any
>help in this.
>
>Thanks, Gary
>
>
|