To: | <spridgets@Autox.Team.Net> |
---|---|
Subject: | Bushing |
From: | "Gary Barker" <gbarker@citynet.net> |
Date: | Sun, 29 Nov 1998 11:43:39 -0800 |
Reply-to: | "Gary Barker" <gbarker@citynet.net> |
Sender: | owner-spridgets@Autox.Team.Net |
I was going through the Moss Catalog and was ordeing 4 trunnion bushings. At the bottom of the page, there was a note that you needed a reamer tool in order to install thies bushes. The cheapest I've found this tool in for $199.00. I don't want to pay this amount for a tool I'll probably just use for this one time instilation. My questionis: Is there a way to fit these bushings without this tool? And if so, how do you do it? I appreciate any help in this. Thanks, Gary |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: Thanks, engine pull, now clutch, Lancer7676 |
---|---|
Next by Date: | Re: Bushing, Leo S. |
Previous by Thread: | Midget Car Pictures, Mark Endicott |
Next by Thread: | Re: Bushing, Paul A Asgeirsson |
Indexes: | [Date] [Thread] [Top] [All Lists] |