Adrian,
Personally, I have always drilled a few small holes in the nylon, enough
to be able to break it. Just go easy with a small drill. Good Luck Peter C
At 06:05 AM 10/26/98 -0800, Bill & Cindy wrote:
>At 06:06 PM 10/25/98 -0500, you wrote:
>>I am taking the brake master cylinder (1500 midget) apart for a
>>rebuild. Each consecutive part gets more and more annoying to remove.
>>I am to the nylon guide bearing and seal. Haynes says to gently move
>>the piston in and out to loosen it up so it will come out. Yeah right.
>>Any other ideas how to get that sucker out? Thanks!
>>
>>adrian
>>
>
>>Adrian,
>
>Just did ours also (1275cc Sprite) and finally ended up using a small slide
>hammer to remove the nylon guide.
>
>Just be carefull not to score the cylinder wall when screwing in the
>hammer's spike.
>Bill
Peter Caldwell
1 very rough Innocenti
(the Sprite with an accent)
among other LBCs and 4WDBCs
|