| To: | "J. Adrian Barnes" <adrian@icx.net> |
|---|---|
| Subject: | Re: More master cylinder stuff |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Sun, 25 Oct 1998 18:22:13 -0500 |
| Cc: | Spridgets <spridgets@Autox.Team.Net> |
| Organization: | Positive Earth Drivers Club |
| References: | <3633AEDE.A19FB386@icx.net> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@Autox.Team.Net |
J. Adrian Barnes wrote: > > I am taking the brake master cylinder (1500 midget) apart for a > rebuild. Each consecutive part gets more and more annoying to remove. > I am to the nylon guide bearing and seal. Haynes says to gently move > the piston in and out to loosen it up so it will come out. Yeah right. > Any other ideas how to get that sucker out? Thanks! Melt it out with a torch. A new on comes with the rebuild kit. -- Frank Clarici Toms River, NJ Lots of LBCs http://www.exit109.com/~spritenut |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: heater, Chuck Ciaffone |
|---|---|
| Next by Date: | Re: a Very Sad thing, Mike Gigante |
| Previous by Thread: | More master cylinder stuff, J. Adrian Barnes |
| Next by Thread: | Re: More master cylinder stuff, J. Adrian Barnes |
| Indexes: | [Date] [Thread] [Top] [All Lists] |