'lo, Robert
You can get a bolt with a standard thread to replace the warning switch.
This is what I did when the new switch I installed didn't stop the leak,
and I didn't want to tear into the assembly again. Take the switch with
you to the hardware store, find a nut that will screw onto it, then find a
bolt to match the nut. That's the bolt you want.
Steve Byers
Havelock, NC USA
'73 Midget GAN5UD126009G "OO NINE"
"It is better to remain silent, and be thought a fool
than to speak, and remove all doubt" -- Mark Twain
----------
> From: robert weeks <robert@woozy.com>
> To: Don.Clark@fluordaniel.com; spridgets@Autox.Team.Net; ncannon
<ncannon@cvn.net>
> Subject: Re: Pressure Failure Switch
> Date: Monday, July 13, 1998 9:05 AM
>
> Hello,
>
> Moss does have a rebuild kit for this, basically it's just the O rings.
My
> catalog shows the new brass piece as being $483 -- that's absurd when you
> consider what's involved with manufacturing that part.
>
> What I'd like to know is if anyone has fashioned some sort of metal screw
/
> plug to replace the plastic switch. My switch has never worked and I
don't
> see any reason to replace it -- I'm not a big fan of idiot lights, call
me
> a DPO if you will, but since I don't ever plan on selling the car I
figure
> I can make this modification without karmic retribution.
>
> Also, I have a spare one of these that I pulled off of my parts car, but
> instead of O rings it has rubber sleeves which seem to not be
rebuildable,
> has anyone seen a rebuild kit for this style?
>
> Thanks,
>
> Robert Weeks
> Durham NC
> 1969 Midget
> 1968-70 Abitza
> http://www.woozy.com/midget/
>
>
>
> At 6:28 AM -0400 7/13/98, Don.Clark@fluordaniel.com wrote:
> > Norm,
> >
> > I am very interested in this answer. I am restoring my '72 Midget
and
> > this past weekend, after replacing my master cylinder and bleeding
the
> > brakes, brake fluid comes flowing out of this switch. It is
plugged
> > for now with a bolt. I hope I don't have to replace the $450.00
> > pressure warning assembly.
> >
> > Don
> > '72 Midget
> >
> >
> >Subject: Pressure Failure Switch
> >Author: ncannon@cvn.net (ncannon) at fdinet
> >Date: 7/11/98 8:11 AM
> >
> >
> >While flushing the brake lines on my 1976 MG Midget I noticed a drip
> >from the pressure failure switch in the pressure warning assembly. I
> >added a little air pressure and a pin hole stream of alcohol flowed from
> >the switch. Can I replace just the switch or should I replace or
> >rebuild the entire assembly?
> >
> >Thanks in advance for all help!
> >Norm
> >
>
>
|