Re: Fasteners

[Brian Evans <brian@uunet.ca>]

Be careful with stainless fasteners in non-stainless holes, so to speak.
Stainless can gall badly, and effectively seize in holes pretty easily, and
it's so hard that it's almost impossible to drill out.  I've had stainless
sheet metal trim screws seize to the point where they had to be ground out -
drillng didn't work.

Cheers, Brian 
>I have had good luck with an industrial supply house where I
>ordered some of this hardware along with some 1/4 and 5/16
>fine thread nyloc nuts--all stainless.