Hi, Jeff! I don't know about the Bugeye, but I just recently replaced this
seal on my '73 Midget. The one I replaced (I'm pretty sure it was the
original), just overlapped the wiper ferrules a bit, so I installed the new
one to do the same (i.e., I didn't trim around the ferrules). It seems to
work fine like this, and doesn't leak.
Steve Byers
Havelock, NC
'73 Midget GAN5UD126009G "OO NINE"
"It is better to remain silent, and be thought a fool,
than to speak, and remove all doubt." -- Mark Twain
----------
> From: Jeff Church <jchurch@exis.net>
> To: Sprite List <spridgets@Autox.Team.Net>
> Subject: Windscreen rubber-continuing saga
> Date: Sunday, October 26, 1997 5:34 PM
>
> Hi all,
> I have a feeling someone has done this before so I thought I'd ask the
> question here.
> I just replaced the windscreen rubber on my '59 Bugeye. Took forever to
> figure out how the thing went on in terms of the direction of the seal.
> Anyway, once the windscreen is on, the seal extends forward approximately
> 1-1/2". That is it covers up about half of the wiper ferrule holes. Does
> one trim this to make room for the ferrule and its accompanying rubber
> seal? or does one trim the windscreen rubber just slightly and use it as
> part of the ferrule seal? My original had been trimmed to go around the
> ferrule, but I wasn't too sure if that was correct. None of my photo
> resources clearly show what is done in this situation. Original Sprite
and
> Midget doesn't even show how it is done. Any help on this matter is
> greatly appreciated.
>
> Jeff Church
> AN5L 11627
|