Hey Paul,
I am in the same situation. I think the flinger distance from end of axle
is important. The rest should be apiece of cake.
http://www.ljvaughan.homestead.com/axlehub.html
Larry
----- Original Message -----
From: "Paul Grafelman" <pdgrafelman@hotmail.com>
To: <spitfires@Autox.Team.Net>
Sent: Sunday, January 16, 2005 2:04 PM
Subject: Hub to flange spacing
> List,
>
> Re-assembling the rear-end on my 77 Spit. Can anyone tell me the correct
> distance from the outside face of the flange to the outside face of the
hub
> once assembled? I am concerned that I installed the hubs too far onto the
> shafts. That or the flanges are not far enough on-to the shafts. Either
way
> my drums are not fitting correctly. Also, anyone know a good way to torque
> the flange nuts (124 ft lbs) with the shafts installed?
|