Re: Additional Suggestions for Manifold Removal? (Was Open-End

["James Carruthers" <j.carruthers@rave.ac.uk>]

EVen better is 1/4 drive with a wobble bar....




William Davies said:

>
> I've had good luck in the past by using 3/8" drive sockets rather than
> the 1/2" variety. It's a few years since I've had to do this, but as I
> remember I used a knuckle jointed bar rather than a ratchet - this gave
> enough articulation to loosen and tighten the nuts under the manifold,

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool
///  Archives at http://www.team.net/archive