spitfires
[Top] [All Lists]

Fw: 6V or 12V coil ??

To: "Flinthoof Ponypal" <Flinters@picarefy.com>, <sfgator2@juno.com>
Subject: Fw: 6V or 12V coil ??
From: <ptegler@gouldfo.com>
Date: Mon, 4 Feb 2002 14:51:34 -0500
I believe you may have missed the point of the 12v to 6V setup

The 12v coil stock setup had 12V going to it all the time.
That is ...during cranking and during normal running.

The latter systems using a 6v coil, while cranking, gets a straight
shot of +12V to help start the car (overdrives the coil a bit).  After 
 the solenoid de-energizes,( when you release the key after starting)
 the 12V signal is disconnected and V+ power is fed to the 6V coil via 
a ballast wire in the harness and or through a fixed ballast resistor 
wired in series with the coil (usually mounted right near the coil on the fire 
wall.)

The newer (oem) elec ign. systems were designed around a roughly
3-5 amp draw though the modules to power the coil.  So a constant
running condition of  12V / 1.8 ohm = roughly 6.66 amps wouldn't cut it.

A resistance is placed in series with the coil. do the resistance value of the 
ballast,
voltage is 'dropped' across the ballast, bringing the level the coil+ side sees
to something closer to 6-9 volts. This power level was conducive to the type
of electronics used in the day.

Neither has any advantage over the other in spark power delivered.....except
maybe the 'high output' during cold startup.

This is also the real problem some people have with converting to elec ign.
Some of the aftermarket setups don't take kindly to only being fed by 6-9 volts
when the systems are plugged directly across the old coil and wiring.
So do... and some only work right if you tap +12V for the 'hot' side of the 
module.

Paul Tegler     ptegler@gouldfo.com    www.teglerizer.com

 

----- Original Message ----- 
From: "flinters" <flinters@picarefy.com>
To: <sfgator2@juno.com>
Cc: <spitfires@autox.team.net>
Sent: Monday, February 04, 2002 2:31 PM
Subject: Re: 6V or 12V coil ??


Starting with Mk III's, Triumph went to 12 volts negative ground.  To my 
knowledge, there has never been a 6 volt  Spitfire.  Using a 6 volt coil 
in a 12 volt system only causes excessive heating and stress on the coil 
and won't necessarily give you a 'hotter' spark.  

///  spitfires@autox.team.net mailing list
///  or try  http://www.team.net/cgi-bin/majorcool


<Prev in Thread] Current Thread [Next in Thread>