I always thought that you could make one by welding a ~3" long
piece of ~3" diameter pipe to the center of a stock
steel wheel, and welding a big nut at the end of the pipe.
Finally, put a bolt in the nut to do the actual pressing.
Doug Braun
'72 Spit
At 12:25 PM 7/5/01 , Joe Curry wrote:
>I have a friend here locally who is trying to replace the wheel bearings on
>the rear of his Spit. He can't figure out how to get the hubs off. I
>have indicated to him that there is a special tool for removing them, but he
>can't locate anyone who has it locally.
>
>Can someone tell me:
>
>1. Where I can buy one of these?
>
>2. Is there somewhere I can find a pattern to manufacture this tool?
/// spitfires@autox.team.net mailing list
/// To unsubscribe send a plain text message to majordomo@autox.team.net
/// with nothing in it but
///
/// unsubscribe spitfires
///
|