I don't know if it is recommended but I've cleaned up flywheels for both my
Spit and GT6 using fine emery paper and have had no problems. I did not notice
any significant pitting in either case.
Gary Kristjansson
68 Frankenspit
71 GT6
>>> <Tburke4@aol.com> 09/25 1:49 pm >>>
Hello Folks,
After my engine was marooned at the local gas station all Summer (don't ask),
I am finally getting it back together. I dug out the flywheel and it has a
nasty layer of rust on the side that faces the clutch. There may be some
light pitting beneath the rust. Is this something I can just clean up with
emery cloth or should I get it resurfaced at a machine shop. I'm concerned
about resurfacing for fear it might cause problems with clutch engagement.
TIA,
Tom Burke
80 Spit
|