Rustbusters wants 20,000 for their setup. A little rich for my home garage.
At 08:38 PM 26/04/2000 -0700, Ken Gano wrote:
>Many (30+) years ago Smith Equipment made a powder spray torch that was used
>for applying hard surfacing. I don't know if they still have it in their
>catalog, but it sounds similar.
>
>Ken Gano
>
>
>-----Original Message-----
>From: owner-triumphs@autox.team.net [mailto:owner-triumphs@autox.team.net]On
>Behalf Of Fred Thomas
>Sent: Wednesday, April 26, 2000 1:53 PM
>To: triumphs@autox.team.net
>Cc: spitfires@autox.team.net
>Subject: new product
>
>
>This is listed in "Old Car Weekly" and I quote from the article
>"Rustbusters"wire feed spray welder allows the shop to repair rusted areas
>faster than cutting a panel out and welding a new one in. No bondo,
>fiberglass, or patch panels, By spraying pure metal onto the sandblasted
>areas, rust holes are filled in, while the surrounding area is galvanized.
>The metal bonds mechanically to cars body at 40,00 lbs. PSI, and can be
>applied as fine as one thousandth of an inch to one foot thick, the method
>can be used anywhere metal rusts.
>Rustbusters
>PO box 341
>Clackamas, OR 97015
>503-223-3203
>This should be a big help for the restorer if the price is allowable. "FT"
Mark Milotay, Principal
On the Mark Software & Consulting
|