In a message dated 02/21/2000 9:54:52 PM Central Standard Time,
jmcneal@ohms.com writes:
<< The wheel is tight to the hub adapter, which is also on tight to
the hub. There seems to be about 1/16" of play. I noticed that the front
rotor seems to be wobbling along with the tire also. Something obviously
needs to be tightened up.
What now? I'm assuming that I need to remove the wheel and hub adapter,
then tighten the four nuts that secure the rotor? The large center hub nut
itself? Any advice or suggestions would be appreciated. I want to make
sure my wheel stays ON this time! >>
Did you check the trunnion and the upper ball joint? Could be a little wear
in either of those bits.
Scott
ScottBarr8@aol.com
|