To clarify..
This '67 has a 1500 engine in it from a '74, it also has the transmission to
match. I did the spring swap some time ago as well as the front sway bar.
So, can anyone tell me if the stub axles have an end float??? I think I
might put the '76 into it since I have the engine and tranny from a later
model.
Thanks everyone for the info you have provided.
Nick
N.A. Campiglia III
'67 Spitfire MKIII
'74 Spitfire 1500
http://camalott.com/~spitdrvr
----- Original Message -----
From: Andrew Mace <amace@unix2.nysed.gov>
To: N.A. Campiglia III <spitdrvr@camalott.com>
Cc: Spit list <spitfires@autox.team.net>
Sent: Friday, September 24, 1999 8:46 PM
Subject: Re: Rear End Stuff????
> On Fri, 24 Sep 1999, N.A. Campiglia III wrote:
>
> > Can someone please tell me what the gear ratio in a '67 Spit is?? Also,
in
> > a '76 that was brought over from Sweden.
>
> Assuming you are referring to the "final drive" (differential), it is
> 4.11:1 on the '67. I think it is probably 3.63:1 on the '76, as it was
> for most non-Federal Spitfires.
>
> > I was replacing the pinion seal tonight and I noticed the stub shafts
were
> > moving in and out. Do these have end float? Anyway, I was thinking of
> > changing the rear with one from the a fore mentioned '76.
>
> I don't know about the "stub shafts"; however, it doesn't sound right to
> me. You can change the diff. complete into the '67, but you'll also need
> to bring over that rear swing-spring (and, therefore, the fatter front
> sway bar). Either that, or you need to drill the extra two holes for the
> 5th and 6th hold-down studs for the original leaf spring. Oh, and you'll
> also need the axle flanges and rear propshaft flange from the later car,
> as the flanges on the '76 diff. are larger. Forunately, the u-joints are
> the same regardless. In other words, it's not quite a direct swap. And
> it's hard to say if the (likely) 3.63:1 ratio will be as suitable in the
> older car (you didn't specify which engine that car has: 1147 or 1296 or
> ???).
>
> --Andy
>
> * * * * * * * * * * * * * * * * * * * * * * *
> * Andrew Mace, President and *
> * 10/Herald/Vitesse (Sports 6) Consultant *
> * Vintage Triumph Register <www.vtr.org> *
> * amace@unix2.nysed.gov *
> * * * * * * * * * * * * * * * * * * * * * * *
|